Pontiac solstice owners manual 2007

Turn the ignition OFF. Disconnect the negative battery cable. Disconnect the engine harness electrical connectors 2 from engine control module ECM. Release the upper retaining tab using a small screwdriver or other suitable tool.

Remove the ECM by lifting upward after releasing the tab. Installation Procedure 1. Slide the ECM into the bracket. Push down on the ECM until the retaining tab snaps into place. Connect the engine harness electrical connectors 2 to the ECM. Connect the negative battery cable. Reset the clock and preset radio stations. Engine Control Module Programming and Setup U The following service procedures require either a programming or a setup event be performed for a complete repair.

Setup for Component Replacement For 2. Attempt to start the engine, then release the key to ON, vehicle will not start. After approximately 10 minutes, the telltale will turn OFF. Start the engine. You must turn the ignition OFF before attempting to start the vehicle. The scan tool only displays the condition that inhibits the procedure.

Install a scan tool. With a scan tool, select the CKP system variation learn procedure and perform the following: 3. Observe the fuel cut-off for the applicable engine.

Block the drive wheels. Set the parking brake. Apply and hold the brake pedal for the duration of the procedure. Start and idle the engine. For example, more than one entertainment system may be offered or your vehicle may have been ordered without a front passenger or rear seats.

Keep this manual in the vehicle, so it will be there if it is needed while you are on the road. If the vehicle is sold, leave this manual in the vehicle. Part No. All Rights Reserved. If this is done, it can help you learn about the features and controls for the vehicle. Pictures and words work together in the owner manual to explain things. Index A good place to quickly locate information about the vehicle is the Index in the back of the manual.

It is an alphabetical list of what is in the manual and the page number where it can be found. Safety Warnings and Symbols There are a number of safety cautions in this book. In the caution area, we tell you what the hazard is. Get your hands on the complete Pontiac factory workshop software. Check out our popular Pontiac Solstice Manuals below:. Summary of Content. Oxnard, Ca. Installing a Borla Performance Exhaust System on your vehicle will eliminate the restrictive design of the stock exhaust, allowing your engine to discharge exhaust gas easier.

The result is more horsepower and torque, longer engine life, and a distinctive throaty growl- all this, with easy bolt-on installation. These installation instructions have been written to help you in the installation of your Borla Performance Exhaust System. Please read it completely before installing your system. Borla Performance Industries recommends that an exhaust shop or professional after market parts installer, who has all the necessary equipment, tools and experienced personnel needed for proper installation, should perform the installation of this system.

However, if you decide to perform the installation, we recommend someone should help you. Ensure the installer uses all under car safety precautions including eye protection.

Please take time to read and understand the following… By installing your Borla Performance Exhaust System, you indicate that you have read this document and you agree with the terms stated below.

Included with your Borla Performance Exhaust System is a warranty card. Please read it carefully before you begin any work on your vehicle. If you should have any questions regarding our warranty policy, installation, or any other matter pertaining to your new Borla Performance Exhaust System, please give us a call at the number provided on the warranty card.

Front pipe assembly Mid pipe Muffler assembly 2. Never work on a hot exhaust system. Serious injury in the form of burns can result If the vehicle has been in use and the exhaust system is hot, allow vehicle to cool for at least 1 hour. Always wear eye protection when working under any vehicle.

Taking all under car safety precautions, lift the vehicle using a hoist or hydraulic lift.